Help centre

Conversions

Drawing analysis: check values and their sources

See the material, dimensions, tolerances and other values read from your drawing, and where on the drawing each one was found.

Last updated 12/11/2026

When you convert a technical drawing, Voluminate also reads the drawing and lists the technical information it finds, such as material, dimensions and tolerances. You can check each value against the spot on the drawing it was read from.

Open the drawing analysis

  1. Open the part from your Workspace.
  2. Scroll down to the tabs below the model. Drawing data is open by default.
  3. Under Extracted from your drawing, check the summary of material, dimensions and tolerances. Click Review drawing data to see every value next to the drawing.

What Voluminate looks for

Material, dimensions, tolerances and GD&T, surface roughness, weight, heat treatment and coating, threads and fits, manufacturing process, quality and inspection requirements, revision and ERP data, and cost drivers.

Extracted, estimated or not available

Each value has a label:

  • Extracted: read from your drawing.
  • Estimated: inferred by the analysis, not stated on the drawing. The reason is shown below the value. Always verify estimates before manufacturing.
  • Not available: not found on the drawing.

The confidence badge shows how certain the AI is of its reading or estimate: High (85% or more), Medium (60–84%) or Low (below 60%). Hover over it to see the exact percentage. Confidence is not a verified accuracy score.

See where a value came from

  1. In the Extracted drawing data window, click Show source beside a field, or click the field itself.
  2. The drawing zooms in and outlines where the value was found. The text read there and the drawing zone appear below the drawing.
  3. Use the zoom buttons or drag to move around. Click Fit drawing to see the whole sheet again.

If Show source is greyed out, there is no verified location for that value. Check it against your original drawing.

Good to know

  • Dimensions are read from your 2D drawing, not measured on the 3D model. For the measured size of the model, open the 3D measurements tab.
  • If your app language is not English, the values are translated automatically. Click Show original (English) to see the original text.
  • If no values were read for a part, for example an older part, the tab shows No extracted drawing data is available for this part yet.

Ready to try it on your own part?

Your first 3D model is free, no credit card required.

Start free